The E30EW85GSS is the Designer G-generation Icon double oven. Heavy daily use of the upper cavity wears its convection fan first, while the lower oven’s bake element fails most often from spills that land on it. We read the revision on an E30EW85GSS before ordering controls, as GSS1 through GSS4 are not all interchangeable.

The E30MC75JSS stacks a microwave over an Icon wall oven. When the microwave runs without heating while the oven works, the microwave’s high-voltage parts are tested; the oven is not involved. F30 on the oven side of an E30MC75JSS points to the oven temperature sensor circuit.

The E30EW75EPS is the pro-handle build of the E-generation Icon single oven. On this generation the display shows short codes, and the full code is read through a service sequence before a part is chosen. A door that stays locked on an E30EW75EPS after self-clean usually means the lock motor or its switch has failed; […]

The E30EW75GSS is the Designer-series G-generation Icon single oven. F10 on it means the oven reached a temperature it did not call for, and a relay stuck on the control board is tested alongside the sensor. Uneven baking in convection mode on an E30EW75GSS points to the convection fan or its element.

The E30EW85ESS is the Designer version of the E-generation Icon double oven. With two cavities, the working oven proves that power and the main control are fine, and we focus on the elements, sensor and relay of the one that failed. F9 on an older Icon oven like the E30EW85ESS points to the door lock […]

The EW27MC65PS combines two very different appliances in one cabinet. When only the microwave stops heating, the problem is almost always inside the microwave section: its door switches, high-voltage parts or magnetron. Microwave repairs on an EW27MC65PS involve high-voltage parts that hold a charge after power is off, so we discharge and test them rather […]

The ECWD3012AS is a recent double oven, and early calls often concern installation: doors that do not sit square after the oven was pushed into a tight cutout, or a circuit that does not match the rating plate. For heat errors on an ECWD3012AS, we follow Electrolux’s guide: turn it off, let it cool, reset […]

The ECWS3012AS is sometimes delivered from a showroom or builder with demo mode active, where the display works but the oven never heats. Electrolux’s oven guide explains how to turn demo off from the settings. After that, an ECWS3012AS that truly will not heat gets its elements, sensor and control relays tested in order.

The E30EW75DSS is one of the oldest Icon wall ovens we still see. Its control shows short codes such as F1, F3 and F9, and the full three-digit code is only visible from a service sequence, so we read that before choosing a part. On an E30EW75DSS, F3 can mean the temperature sensor or a […]

The ECWM3012AS pairs a full oven with a microwave in one tall unit. The microwave and oven have separate heating parts, so a failure in one leaves the other working, which helps us narrow the problem quickly. Both sections of an ECWM3012AS share a cooling fan path. If the fan fails, heat builds around the […]