What E67 Means
E67 is a heater sensing relay failure. Electrolux front-loaders with an internal water heater switch it with a relay on the main board, and the board also checks that relay; E67 means that check failed. Test 13 measures the heating element (about 14 ohms) and its insulation to ground before the board is blamed.
Common Causes of E67
- Heater relay on the main board failed
- Heating element out of range
- Wiring to the heater damaged
🔧 One Safe Check You Can Try
Run a cold-water cycle to see whether the washer finishes normally without heating. Many loads wash fine cold, and knowing that the washer otherwise works helps the technician focus on the heating circuit.
⚠ Why You Shouldn't Go Further Than That
- The heating element is mounted in the bottom of the tub and removing it can let water out.
- Relay and element checks involve 120 V circuits.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.
Technical Reference
- Code
- E67
- Appliance
- Electrolux washers
- Maker documentation
- Electrolux owner manuals and use & care guides
- Checked
- September 2026
Code meanings can change between control generations. Before acting on a code, match the full model number on your appliance's rating label against the manual for that model. We are an independent repair service, not affiliated with Independent service.