What Charcoal Filter Means
Charcoal Filter is not an error. On the same glass-touch range hood family set up for recirculating (ductless) use, Electrolux’s guide says the display flashes “Charcoal Filter” after one hundred twenty hours of fan run time to show that the charcoal filters need to be replaced.
Common Causes of Charcoal Filter
- One hundred twenty hours of fan run time reached on a recirculating installation
- Charcoal filter alarm left switched on after the hood was converted to vent outside
🔧 One Safe Check You Can Try
Replace the charcoal filters — Electrolux’s guide says they cannot be rinsed or put in a dishwasher — then hold the minus button for 5 seconds to clear the message. If the hood is ducted to the outside rather than recirculating, the guide says holding the plus and minus buttons together for 5 seconds, with the lamps and motor off, turns this alarm off for good.
⚠ Why You Shouldn't Go Further Than That
- No repair is needed; replacing the charcoal filters is routine maintenance.
- If the message returns immediately after fresh filters are installed and the alarm is reset, the touch control board is worth having looked at.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.
Technical Reference
- Code
- Charcoal Filter
- Appliance
- Electrolux range hoods
- Maker documentation
- Electrolux owner manuals and use & care guides
- Checked
- September 2026
Code meanings can change between control generations. Before acting on a code, match the full model number on your appliance's rating label against the manual for that model. We are an independent repair service, not affiliated with Independent service.